Team:BostonU HW/TERRA Adaptor

Argon Design System - Free Design System for Bootstrap 4

Argon Design System - Free Design System for Bootstrap 4

TERRA Adapter

Creating the TERRA Adapter

The TERRA Adapter is a scalable, predesigned chip that is capable of selectively dispensing the output of the microfluidic chip running the experiment into the intended lab vessel. The TERRA Adapter serves to increase the number of and types of microfluidic chips that are compatible with our system. This makes the system more user-friendly, as they don’t have to design a chip that both completes a biological experiment and is capable of selecting the proper output to be dispensed. For droplet based experiments, the TERRA Adapter has two valves and a set of four pressure regulators per output. In continuous flow experiments, there are two valves for every output and an extra output that serves as a flush mechanism for cleaning the nozzle between outputs, but no pressure regulators.

After a discussions with Fraunhofer and Phenomyx about the lack of standardization in the microfluidic industry, and seeing the advantages of making our system compatible with commercial microfluidic chips, the output selection mechanism was made to be its own chip, the TERRA Adapter. Output selection is a necessary part of TERRA because the system needs direct control over when the output of the microfluidic chip is dispensed despite the fact that the flow into the chip is continuous. With the TERRA Adapter, the experimental chip can be either user-designed or bought commercially because it does not have to include a built-in output selector, but in not run in conjunction with a TERRA Adapter.

Output Selector with Pressure Regulators
The first features resembling a TERRA Adapter were the valve-based output selectors used the initial versions of our proof of concept chips. An output selector is a combination of two valves and two ports that work in tandem. When one valve is open, the other is closed. This means that the input only going to one of two outputs at any one time, and when the valves are actuated, the output the liquid is flowing to is switched. Using this concept, our simple two-valve output selector system controls when an input is flowing to waste and the output nozzle, allowing direct control over when the output is dispensed. The output selector used in the 4-Pressure Regulator chip is identical to those in the finalized branches of a droplet-based TERRA Adapter.
The TERRA Adapter works for both droplet-based and continuous flow microfluidics. For droplet based experiments, the TERRA Adapter has two valves and a set of four pressure regulators per output. The pressure regulators serve to minimize the disruption in droplet generation on the experimental chip due to the pressure difference caused by the actuation of the valves in the output selector. In continuous flow experiments, there are two valves for every output, there are no pressure regulators, but there is an extra output that serves as a flush mechanism for cleaning the nozzle between outputs.

Below are some TERRA Adapters that our team has created so far:

Single Output, Continuous Flow
Single Output, Droplet-Based


Three Output, Continuous Flow
Three Output, Droplet-Based



Scalability

The TERRA Adapter is scalable following radial symmetry about the nozzle output, as seen in the diagram below. The continuous flow TERRA Adapters also follow this symmetry but an extra branch has to be added to each design, except that of a single input, to serve as a flush to clean the nozzle between outputs.



While there is no design limit to the number of branches a TERRA Adapter can have, there exist a fabrication limit as to the number you can feasibly mill on a chip, depending on the method of fabrication and size of chip, the fabrication limit of the TERRA Adapter will differ. Using our current fabrication method and chip size, the largest TERRA Adapter we could manufacture would be one with 5 inputs.