Difference between revisions of "Team:ZJUT-China/Results"

Line 1,272: Line 1,272:
 
           </p>
 
           </p>
 
           <h2>(3)Maximize the repression effect.</h2>
 
           <h2>(3)Maximize the repression effect.</h2>
           <p>①Strain contained target plasmid was cultured in the test tubes with liquid minimal medium. And the concentration gradients of arabinose were set in these tubes(2×10-5M,4×10-5M,8×10-5M,1.6×10-4M,3.2×10-4M).
+
           <p>①Strain contained target plasmid was cultured in the test tubes with liquid minimal medium. And the concentration gradients of arabinose were set in these tubes(2×10<sup>-5</sup>M,4×10<sup>-5</sup>M,8×10<sup>-5</sup>M,1.6×10<sup>-4</sup>M,3.2×10<sup>-4</sup>M).
           </p>  <p>②OD600 and GFP values of the bacterial culture were measured periodically with the automatic microplate reader. For green fluorescence, excitation and emission wavelengths were 395 and 509 nm.
+
           </p>  <p>②OD<sub>600</sub> and GFP values of the bacterial culture were measured periodically with the automatic microplate reader. For green fluorescence, excitation and emission wavelengths were 395 and 509 nm.
 
             </p>  <p>③Draw charts using measured data to observe the trends of repression.
 
             </p>  <p>③Draw charts using measured data to observe the trends of repression.
 
           </p>
 
           </p>

Revision as of 11:03, 17 October 2018

Team:ZJUT-China - 2018.igem.org

Loading menubar.....

Team:ZJUT-China

Light-controlled system

3.Experimental results

3.1.Detection of expression efficiency of primary light control system in different hosts

Figure 5. expression efficiency of primary light control system in DH5α
Figure 6. expression efficiency of primary light control system in BL21
Figure 7. expression efficiency of primary light control system in 4MG1655
Figure 8. expression efficiency of primary light control system in BW25113

3.2.Detection of PCR results of PT7 promoter (insertion fragment) and deleting PJ23100 promoter (linearized carrier) by electrophoresis gel

Figure 9. Analysis of PCR products by electrophoresis gel

3.3.Detection of de-template results by electrophoresis gel

Figure 10. Analysis of de-template products by electrophoresis gel

3.4.The results of secondary light control system effect detection

Picture 11. curve of relationship between IPTG dosage and fluorescence value in experimental group


sgRNA-cm

Test Crisper/Cas9 system

After two transforming and the transformed plates placed in 30℃ devices overnight, E.coli MG1655+ΔpanD grew, E.coil MG1655 wild type died.It showed Crisper/Cas9 system can work.

Table 1. Transformants culture result

Our target:

GTCCTAGGTATAATACTAGTGGCAATGAAAGACGGTGAGCGTTTTAGAGCTAGAAATAGC

sequencing results :

sequencing results showed construction successfully.

Test pTargetF-cm

After final transforming and the transformed plates placed in 30℃ devices overnight. We selected the strain and culture it both in LB+kan+spec and LB+cm. And the strain grew in LB+kan+spec, while it died in LB+cm(Fig.1).

Figure 1. The result of culture


PBAD-Cas9

Fig.1 Growth curve, add 10mM ara after 3 hours of culture
Fig.2 Growth curve, add ara after 5 hours of culture

In our experiment we required transformation data and two growth curve in the end. Fig.1 shows that after adding arabinose, E. coli MG1655 with PBAD-Cas9 plasmid stopped growing. We use OD600 to characterize the cell amount proving that the expression of Cas9 protein can be regulated by 10mM arabinose. Fig.2 shows how different concentration of arabinose affects the Cas9 expression.

In the chloramphenicol gene cleavage experiment, we used a plate containing ara for transformation experiments, and the cleavage of the chloramphenicol gene can be characterized by transformation efficiency. The results are shown in Table 1:

Our results show that inducing the expression of Cas9 by ara has no effect on the transformation efficiency of wild type, and the transformation efficiency of E.coli cmR is greatly reduced. Therefore, we can conclude that the transformation efficiency is reduced because Cas9 cleaves the chloramphenicol gene on the genome under the guidance of sgRNA-cm. Moreover, when we did not add Ara, the transformation efficiency of E.coli cmR was also lower than that of E.coli wild type. This suggests that Cas9 exhibits high gene cleavage efficiency in bacteria because PBAD is a well-regulated promoter.


Light-controlled Cas9 system

Under light and dark conditions, the transformation efficiencies with pTargetF-panD were 1.185 and 1.295 folds of thoese with pTargetF-cm respectively, demonstrating that pTargetF-cm could guide Cas9 to the cm gene on the genome and resulted in the decrease of transformation efficiency. The result also reflect that the blue light provided cannot completely suppress the expression of CRISPR/Cas9. It is also remarkable that the transformation efficiency with pTargetF-cm under the dark condition was lower than that under the light condition, indicating that the CRISPR/Cas9 system showed stronger activity under dark condition, achieving the purpose of cutting a resistance gene with the light-controlled CRISPR/Cas9 system.

Table 2.Number of transformants
Figure 2. Results of transformation experiments


Repression system

▶First step

Aim

We’d like to achieve the following purposes:

1、Construct a part with repression system.

2、Maximize the repression effect.

3、Select a more suitable system through comparison.

Experimental details

●lacI-Plac

(1)Obtain Objective strain

For testing this device we used DH5alpha cells which contain the plasmid named pGLO-lacI. This plasmid contains the parts (BBa_K2556032) we want to test. The steps are as follow:

①pCAS was cultured in the test tube with liquid LB medium. After 12h, we extracted the plasmid DNA and measured the concentration.

②We prepared the insertion fragment and the linearized carrier(pGLO)by PCR. Then the PCR product was de-templated by DpnⅠ. Finally PCR product was purified by TaKaRa kit to prepare for ligation.

③Construction of plasmids named pGLO-lacI by One step cloning

④Transform the pGLO-lacI into E.coli DH5α by Heat Shock and 10-100μL plated on antibiotic selective media(AMP).

⑤Colony PCR and we selected ideal colonies, sequenced by company ,preserved the strain and began to test the effectiveness of the repression system.

Verify the function of repression of lacI

①Strain contained target plasmid was cultured in the test tubes with liquid minimal medium. Different conditions are set in each test tube and the conditions can be seen clearly from the chart below. (Parallel three groups)

②OD600 and GFP values of the bacterial culture were measured periodically with the automatic microplate reader. For green fluorescence, excitation and emission wavelengths were 395 and 509 nm.

③Draw charts using measured data to verify the function of repression of lacI

(3)Maximize the repression effect.

①Strain contained target plasmid was cultured in the test tubes with liquid minimal medium. And the concentration gradients of arabinose were set in these tubes(2×10-5M,4×10-5M,8×10-5M,1.6×10-4M,3.2×10-4M).

②OD600 and GFP values of the bacterial culture were measured periodically with the automatic microplate reader. For green fluorescence, excitation and emission wavelengths were 395 and 509 nm.

③Draw charts using measured data to observe the trends of repression.

●cI-PR

The same as above.

●lacI-Plac

(1)Verify the function of repression of lacI

The time history plot of Relative Fluorescence Unit of the objective strain(The strain contains the plasmid named pGLO-lacI) under different conditions is shown in Fig.1

Fig.1 The Relative Fluorescence Unit of the objective strain

(2)Maximize the repression effect

The time history plot of Relative Fluorescence Unit of the objective strain(The strain contains the plasmid named pGLO-lacI) under different concentration of arabinose is shown in Fig.2

Fig.2 The Relative Fluorescence Unit of the objective strain

●cI-PR

The time history plot of Relative Fluorescence Unit of the objective strain(The strain contains the plasmid named pGLO-cI) under concentration of arabinose is shown in Fig.3

Fig.3 The Relative Fluorescence Unit of the objective strain

Conclusions and analysis

①We construct both two parts with repression function (lacI-Plac, cI-PR) successfully.

lacI-Plac: By adding arabinose to induce the expression of LacI protein, the Relative Fluorescence Unit of the objective strain is lower which illustrate the effect of repressor. And, when adding the IPTG, the Relative Fluorescence Unit of the objective strain is higher which also prove the expression of LacI protein.

cI-PR:By adding arabinose to induce the expression of cI protein, the Relative Fluorescence Unit of the objective strain is lower which illustrate the effect of repressor.

②We gain two time history plots which are shown in Fig.2 and Fig.3 respectively.

lacI-Plac: When the concentration of arabinose is 2×10-5M and 8×10-5M,the repression effect of LacI repressor is relatively close. Compared with these concentration, repression effect of LacI repressor increases after 30h under the concentration of arabinose is 16×10-5M and decreases before 40h under the concentration of arabinose is 4×10-5M .

cI-PR:Only when the concentration of arabinose is 2×10-5M, this part could inhibit the transcription of downstream.

②We select lacI-Plac as our final repression system. Because lacI-Plac can maintain the stable effect of repression at different concentrations but cI-PR didn’t show that.

▶Second step

Aim

We aim to use the lacI repression system to regular the transcription of sgRNA which is designed to specifically bind to the gene panD on the E. coli genome.

Experimental details

●lacI-Plac-sgRNA

We constructed two compatible plasmids containing the sgRNA-regulated transcriptional system (BBa_K2556042) and the Cas9 protein, respectively. And then we introduced two plasmids into E.coli MG1655. After obtaining the transformants, we tried to demonstrate the difference of the transcriptional level of sgRNA by analyzing the growth curves in four different conditions (①+2×10-5M Ara +2×10-5M IPTG ②+2×10-5M Ara ③+2×10-5M IPTG ④None) . If sgRNA transcribe correctly, the CRISPR/Cas9 system will be activated. That means the target gene panD will be cut and the E. coli couldn’t survive.

Results

●lacI-Plac-sgRNA

We did three sets of parallel experiments and the result is shown in Fig.4.

Fig.4 The growth curves in four different conditions

Conclusions and analysis

Analysis of the experimental results revealed that the lacI repression system couldn’t regulate the transcription of sgRNA successfully, because the four growth curves in different conditions are very similar. We suspect the lac operator which directly links to the sgRNA affects its conformation so that the sgRNA can’t be unable to function properly.

After consulting the literatures, we demonstrate it was exactly a DNA sequence before the sgRNA that prevented it from maturation. And it also doesn’t work if we add a repeat artificially before sgRNA. Because it has been published that tracrRNA directs the maturation of crRNAs by the activities of the widely conserved endogenous RNase III and the CRISPR-associated Csn1 protein. This limits the use of the CRISPR/Cas9 system in E.coli.

Here we present two solutions. First, try to find a suitable repression system to replace the lacI repression system, which means sgRNA should be linked directly to the transcription initiation site (TSS). Second, activate the type I CRISPR/Cas system in E.coli because of the less limitation in comparison with the type II CRISPR/Cas system.


Lysis

Before genome editing, we first tested the cleavage function of the part containing the genomic homology arm on the plasmid. Our part is built on the T vector. The result is shown in Fig 1:

Fig.1 Growth curve

Our results show that when we added arabinose(the concentration is 10mM) to inducelysin gene expression, the OD600 value of the bacterial culture was significantly lower than that of the control group without arabinose induction. And comparing with adding arabinose after 4.5 h of culture, when we added arabinose at the beginning, the OD600 is lower.

Our vector experiments have initially confirmed that the expression of the lysin gene is effective for cell lysis. Based on the results of this experiment, we inserted the lysis part into the E.coli genome by CRISPR/Cas technology. In order to obtain a transformant that was successfully inserted the part into genome, we screened by plate streaking, and the experimental results are shown in Fig 2:

Fig.2 Result of plate streaking

We selected 34 transformants for plate streaking, and 5 of them showed lysis effects on arabinose containing plates. They were probably the strain we have insert lysis part into genome. And finally we got a strain with a significant lysis effect after arabinose induction, and we named it E.coli MG1655-Lysis. You can see the result in Fig. 3.

Fig.3 E.coli MG1655-Lysis cultured in tubes