Team:GreatBay China/Demonstrate
mCATNIP2018@outlook.com
@Igem2018C
Demonstration
- ✓ Geraniol production by E.coli
- ✓ Conversion of geraniol to nepetalactol by S. cerevisiae
- ✓ Creating a stable microbial consortium of E. coli and S. cerevisiae
Geraniol Production by E. coli
We have proposed two different strategies for engineering a geraniol-producingE. coli strain: over-expressing GPPS and GES, which relies on nativeE. coli MEP pathway to supply IPP and DMAPP; and introducing a heterologous yeast MVA pathway along with GPPS and GES. For realizing these designs, we constructed (Figure. 1 A) pUC20-pTac-GPPS-GES and let Genscript constructed (Figure. 1 C) pMVA-GPPS-GES, and (Figure. 1 B) negative control pMVA for us. After transforming them intoE. coli, we carried out a 24h shake-flask fermentation upon 25μM IPTG induction at a point when the OD600 equaled 1. Then, an n-hexane phase is used for harvesting geraniol from the culture which was analyzed by gas-chromatography.
TheE. coli strain containing pUC20-pTac-GPPS-GES didn’t produce any detectable geraniol titer. Expression of pMVA-GPPS-GES yielded 11.4mg/L geraniol whereas expression of pMVA alone also produced 5.65mg/L geraniol. From this phenomenon we inferred that provision of the precursors IPP and DMAPP by heterologous pathway was necessary for achieving high geraniol yield.
However, we have not yet explored whether this expression level of GPPS and GES was the optimum at this condition. If the expression of GPPS and GES were tuned to suit the flux of precursors, we might see even greater titer of geraniol produced. Nonetheless, although at this moment we aimed at geraniol production byE. coli alone, theE. coli would eventually be co-cultured with S. cerevisiae for the production of nepetalactol. Then, since the change in culturing conditions has agitated the internal environment of the host, the pre-set ratio might be lost. Transcription-activator-like effector stabilized promoters (TALEsp) provided a solution to this problem through a regulatory mechanism employing the incoherent feedforward loop (iFFL).
We decided to utilize TALEsp to uncover the most suitable expression level of GPPS and GES. But the current number of TALEsp available was too small for us to make sensible decisions, which was the reason why we expanded the TALEsp library.
The expansion of the library was based on introducing a number of new core promoters — the TALE-repressible promoters (Figure. 2 A), and assembling them with the genetic circuit encoding for TALE (Figure. 2 B). After adding six more TALEsp, the library then had twelve members, whose performance was characterization by fluorescence given out by the sfGFP they regulated. Besides the TALEsp, we also characterized three constitutive promoters from the J23 consensus promoter family. (Figure. 2 C) Each promoter was placed on three backbones: the high copy pSB1C3, the medium copy pR6K, and the low copy pSC101, so that we could assess the stabilization ability. From the results measured by flow cytometry, we could see that the influence of copy number on fluorescence level has sharply decreased, signifying valid stabilization by TALEsp.
From the library, we chose three TALEsp to geraniol synthesis which were TALE2sp6, TALE2 sp1 and TALE1 sp1 in ascending promoter strength. They along with a pTac promoter were used for driving gene expression of GPPS and GES. Similar to the fluorescence characterization, the constructs were placed on three different vectors of high, medium and low copy. As MVA pathway was a requisite for geraniol production from our previous experience, we transferred the plasmids into theE. coli strain already harboring pMVA that we have created. Because pMVA contained chloramphenicol resistance which was the same as pSB1C3, pUC20 was chosen as the high copy vector for geraniol production assay.
Table. 1 Geraniol production by different promoters and vector combinations
With pTac promoters, geraniol yield increased with the copy number of the vector, showing positively correlated relation. However, when TALE stabilized promoter (TALEsp) was used, higher the copy number of the vector, lower the production of geraniol, being the opposite of pTac. And the stronger TALEsp promoter, TALE1sp1 gave generally reduced yield compared to its weaker counterpart TALE2sp1. TALE2 sp6 whose strength measure with fluorescence is about half of the strength of TALE2 sp1 produced the lowest titre among the four promoters tested. Interestingly, the graphs of the TALE stabilised promoters appeared to be seemingly parallel to each other.
We surmised that the yield of geraniol was affected by two factors: the expression level of enzymes and the cellular burden. As for enzyme expression, there exists an optimal gene expression level that produces just enough enzyme to metabolize all the substrate. The yield would be the greatest at this level. But if lower than this level, production would increase with enzyme expression since there is a surplus of substrates. And if the enzyme expression is higher, the more enzymes now becomes a cellular burden as it no longer contributes to more product.
In the case of pTac, it fits into the scenario when the gene expression is lower than the optimum: higher copy produced more enzymes to catalyze geraniol synthesis reaction. As for TALE stabilized promoters, the expression level of enzymes would remain unchanged regardless of copy number due to the stabilization nature of TALEsp (Go to Design). So in low copy vector where the cellular burden isn’t significant, the product yield is only related to the strength of the promoter, explaining why TALE2 sp1 has better performance than both TALE1 sp1 and TALE2 sp6 as it’s closer to the optimum. But when the copy number increases, the expression level is unaffected while the cellular burden rises sharply because much more TALE would be made to stabilize expression, leaving less energy available for geraniol synthesis. And it in turns answers why a negative trend of production is shown when regulated by TALEsp.
It was reported that TALE stabilized promoters could maintain the level of gene expression without the need for “re-tuning” upon genomic insertion, so we used pOSIP to integrate TALE1sp1, the core promoter of TALE1sp1, TALE2sp1, and the core promoter of TALE2sp1 with the sfGFP into the attB locus in the genome individually and characterized the fluorescence again. The result shows that after genomic insertion, TALE stabilized promoters maintain a higher expression level in comparison to the core promoters which are constitutive promoters. Also, we inserted TALE2sp1-GPPS-GES into the genome to investigate if the trend of geraniol yield increasing on lower copy stayed consistent. In the genome where theoretic copy number is one, geraniol yield rose slightly from the previous level on pSC101, reaching xxxxxmg/L.
Conversion of geraniol to nepetalactol by S. cerevisiae
From literature we have comprehended that fact that the conversion was unlikely unless promiscuous endogenous enzymes were knocked out, so we began expression vector construction and gene deletion at the same time.
At first we usedE. coli as the cloning host for constructing the vector, but to our surprise, no matter what assembly method we used — Gibson or biobrick assembly, theE. coli colony grown always missed the G8H component. After careful debug, we found that pTDH3 contains wild-typeE. coli promoters which have triggered the expression of G8H inE. coli, resulting in cytotoxicity which forcedE. coli to cleave G8H. So later we changed out the method by transforming the ligated DNA directly into yeast and using colony PCR to determine if the construction was successful.
Conversion of geraniol to nepetalactol by S. cerevisiae
When we have eventually acquired the expression vector, the gene oye2 was knocked out. Therefore we started the characterization of using engineered yeast to convert geraniol to nepetalatcol. Having transferred the vector into both BY4741 and △oye2 BY4741, we shared the yeast at 30℃ and fed them with xxxμl 20mM geraniol every two hours for 24h, then used gas chromatography for biocatalytic activity analysis. From the GC result, BY4741 has not produced nepetalactol, but we verified that geraniol was consumed by geraniol and nepetalactol was produced by △oye2 BY4741. However, an unknown metabolite was also generated and in a larger quantity than nepetalactol. Our assumption was that this peak was a shunt product reported. And if oye3 and adh7 were deleted in addition to oye2, it would be very likely that the nepetalactol yield increased and the shunt product decreased. At this moment, the nepetalactol yield we have obtained is 1.267mg/L.